Filter for aquarium in aquarium thing is a necessary thing. One and all aquarium facilities from nano to maxi require filtration and almost all aeration. It is an aqua filter that helps to solve these issues.
The design of different aqua-filters for aquariums is very different, in many aquariums internal filters are used, which are inside the cans completely immersed, even the wires that are connected to the contacts inside the case. The filtration element is also inside the filter, which is covered by a removable plastic cup with a grate. When the filter is rinsed, the beaker is removed, the filter sponge is rinsed, then it is placed inside again and closed in the reverse order.
The filter for the aquarium, designed to work at full immersion in water is produced with a fully sealed electrical part. If the filling of the filter fails, as a rule, it can no longer be repaired, it is very difficult to restore full tightness. With such a failure, it is better to replace the filter with a new one. But if the malfunction is due to external damage, you can attach skillful knobs and restore the normal functioning of the filter at home.
Damage to the electrical wires at the filter output.
Such damage is not so rare. It occurs due to the fact that the wires can be bent, bend at the point of exit from the sealed part. Also from time to time, during long-term operation, the sheath of wires can begin to break, then the conductive wires will become bare. This damage can be identified visually or by the fact of arcing. Damage is dangerous, because the power supply network of 220V and the presence of water can cause a short circuit or even worse, become life-threatening.
Such damage is not difficult to fix with adhesives. Such sealants are of different types, the main thing is that for the inhabitants of the aquarium they are not toxic. Therefore, the choice should be in favor of aquarium sealants. To carry out repairs, the filter must be dried, disconnected and the removable parts removed. Then, using a thin spout of the sealant nozzle, apply the compound to the damage site, completely covering the wire segment and the entrance to the unit where the aqua-filter motor is located. After complete drying, try the updated filter in any container with water and only then use it in the aquarium.
Damage to the filter guard.
Breakage of the grille may occur due to a fall or strong compression of this part of the filter; plastic jumpers are quite thin. The gap can immediately become dangerous for small inhabitants of the aquarium, a small fish or shrimp can easily tighten the flow of water into the filter, where it will die.
There is a way out, the filter is easy to fix. Prepare a synthetic mesh, needle, thin fishing line and scissors. The synthetic mesh can be taken from the packing bag with vegetables or fruit.
Cut off a fragment of at least 20×20 cm, rinse thoroughly with soap and water under running water. Then wrap the glass tightly, and, with the help of fishing line, sew the mesh in the place of addition and in the lower part, having closed it on the bottom of the filter cup.
Sew only with a fishing line, any other threads will not work, in water they will quickly decompose. After such a reconstruction, the filter can serve for a very long time.